Edit A Mode Of A User-Defined Sw/Led - Simplex 4010 Installing And Operating Insructions

Configuring User-Defined SW/LED,
Configure a User-Defined
Switch or LED (continued)
Edit a Mode of a User-Defined
SW/LED
Technical Manuals Online! - http://www.tech-man.com
Continued
Table 6-9. User-Defined SW/LED Configuration Choices
Function Description
Edit Device Type Changes the Hardware Device Type of the Point
(See Notes 1 and 2)
Edit Point Type Changes the Software Point Type of the Point
(See Note 2)
Edit Point Label Changes the 40-Character Label of the Point
(See Note 1)
Clear Point Label Blanks the 40-Character Label of the Point
(See Note 1)
Edit Mode Changes the Mode of Operation for the Point
Notes:
1. This function not allowed for User-Defined SW/LED.
2. Your Point Type choices for LEDs are Yellow LED or NON-
Yellow LED. The switches default to USWITCH point type and is
not editable.
This section describes how to edit the mode of a User-Defined SW/LED. Use
the following steps to edit the mode of a User-Defined Switch or LED in the
4010 FACP.
1. After selecting User Defined SW/LED as your option under the Configure
Points menu, press <NEXT> or <PREVIOUS> to scroll through the
choices listed below. Once your choice is displayed, press Enter.
•
User LED 1
•
User LED 2
•
User LED 3
•
User Defined Key 1
•
User Defined Key 2
2. Press <NEXT> or <PREVIOUS> to scroll through your list of choices until
Edit Mode is displayed and then press Enter. Your modes for Switches and
LEDs are shown in Table 6-10.
6-22
Continued on next page