Other Compatible Equipment - Simplex 4010 Installing And Operating Insructions

Optional System Modules,

Other Compatible Equipment

Technical Manuals Online! - http://www.tech-man.com
Continued
The 4010 is compatible with the equipment listed below provided all equipment
meets the applicable agency listings for the intended use.
•
4003 Voice Control Panel (VCP). Since the 4010 does not contain
hardwired monitor points, the alarm/trouble output from the 4003 is
connected to a Zone Adapter Module (ZAM). One of the NACs on the
4010 can be used to activate the 4003.
•
4009A and 4009R IDNet NAC Extender.
•
The 4010 is compatible with the following 4098 smoke/heat sensors and
bases:
PID
4098-9710
4098-9713
4098-9714
4098-9717
4098-9733
4098-9789, -9791 thru -9793
•
Power supplies that are power-limited and listed for fire-protective signaling
use can be used with the 4010 when wired according to power-limited
guidelines.
•
The 4010 is compatible with the 4120 network. In order to use the 4010 as
a node on the network, you must have
- 4100 master software must be Rev. 8.01 or higher and GCC/NPU must
be Rev. 2.03 or higher.
- 4120 network firmware must be Rev. 3.01 or greater. (Rev. 3.02.99 or
later is recommended.)
- 4010 network firmware must be Rev. 3.03.99 or later.
1-8
Description
Quickconnect, TrueAlarm, Photo
Smoke Sensor
Quickconnect, TrueAlarm, Photo
Smoke Sensor with sounder.
TrueAlarm, Photo Smoke Sensor
(requires separate base)
TrueAlarm, Ion Smoke Sensor
(requires separate base)
TrueAlarm Heat Sensor (requires
separate base)
Sensor Bases