Re-Install The Chassis; Procedure - Simplex 4010 Installing And Operating Insructions
Front panel
Hide thumbs
Also See for 4010:
- Applications manual (85 pages) ,
- Service manual (72 pages) ,
- User manual (9 pages)
Table of Contents
Advertisement
Re-install the Chassis
Procedure
Technical Manuals Online! - http://www.tech-man.com
Use the following steps to re-install the 4010 chassis containing the SFI/O and
power supply into the back box.
1.
Insert two mounting screws into the top two mounting holes for the chassis.
Tighten the screws leaving a 1/8-inch gap from the seated position.
Caution:
When mounting the chassis, pay careful attention to any
wiring inside the back box. Do not crimp any wiring behind
the chassis when mounting.
2.
Carefully hang the chassis on the two top mounting screws using the top
teardrop holes on the chassis.
3.
Insert two mounting screws into the bottom two teardrop chassis mounting
holes and tighten all screws.
4.
Re-hang the door on the back box hinges and re-attach the door grounding
wire to the back box.
5.
You can re-install the retainer now before wiring or later after wiring is
complete. Re-install the retainer by guiding the top lip of the retainer under
the top lip of the back box and carefully sliding the bottom of the retainer
into place.
WARNING: DO NOT APPLY POWER TO THE 4010 AT THIS TIME!
DO NOT connect the quick-disconnect AC connector to
the chassis. Refer to the "Power-Up and Checkout"
section of this publication for more information.
2-5
Advertisement
Table of Contents
Need help?
Do you have a question about the 4010 and is the answer not in the manual?
Questions and answers
On a 4010 what is point label 4009A trouble. I **** not familiar with this
A point label trouble on a Simplex 4010 related to a 4009A booster may indicate that the point assigned to the booster is not properly configured or is experiencing communication issues. This could be due to incorrect dip switch settings, wiring issues, or the point type not being correctly set in the system configuration. All 4009 NACs are automatically set for Class B operation and assigned a point type of SSIGNAL, but manual programming may be needed if Quick CFIG does not resolve the issue.
This answer is automatically generated