Operation Modes; Standard Monitor Mode - Toshiba TOSVERT VF-A5 Instruction Manual

E6580516
7 .3 Operation Modes
This inverter unit has the following four operation and display modes.
- MON
- Status monitor mode
Standard
Page40
monitor mode
-
MON
-
(Frequency setting)
Only when
rnr is
uc...ru
set
Settings
(Status alarms)
-
PRG
:::
monotor mode
(Trip information)
Page 41
PRG
-
PRG
-
-
JOG run mode
Page 44
PRG
7.3.1 Standard Monitor Mode
Standard monitor mode is automatically entered when power is turned on. The inverter's output frequency
can be monitored and the frequency command value can be set in this mode. Status alarms are displayed
while running and trip data is displayed during an inverter trip.
(1) Frequency command value setting function
This function can be used by pressing the
g) (Y)
keys in standard monitor mode. Status monitor
mode can be entered by pressing
I
MON
I
and settings monitor mode by pressing
I
PRG
I.
(Standard
monitor mode will once again be entered if the same key is pressed again. ) If the frequency
command value is changed while running, the operating frequency will change according to the new value.
If the command value is ahead of the operating frequency, the motor will accelerate or decelerate
according to the acceleration/deceleration time.
This function can
be
locked out (changes not possible) with the "frequency setting mode selection"
(!Fnoc1lin
c,.-.ut ).
(2) Forward/reverse run changeover during run function
Forward and reverse run are possible by pressing the following keys in standard monitor mode.
I
ENTER
I
+
~
Forward run
I
ENTER
I
+
[Y)
Reverse run
Note)
l.___~I
key
+I~ -~I
key means to press
the two keys simultaneously.
This changeover is valid only via panel operation, and the setting value of
IF ,-
I
in [, ,-
.F' ,-,
will
also change when these key sequences are executed.
- 37 -