Seal Check And Removal - Ricoh B064 SERIES Service Manual

MFP OPTIONS: B246/D052 SERIES
⇒

Seal Check and Removal

[A]
1. Ensure a customer witness is
present when opening the DOSS
option.
2. Make sure that:
1) The box has two pieces of tape
[A] attached to the corners in the photo, AND
2) These two tapes are blank .
If you can see "VOID" on the surface of the tape, DO NOT install the
components in the box. Stop this procedure and contact the Technical Hotline
via the e-Lert form on the TSC Website. Retain the box and its contents. Any
tampering of the DOSS option will need to be investigated.
4. If the results of Step 1 are OK, remove the two pieces of tape from the box.
Note: After you remove the tapes, you will see "VOID" written on the box under
the tape [B]. This is normal.
5. The procedures outline in this bulletin needs to be followed if the DOSS option
is replaced due to a failure.
CAUTION
Before you begin any procedure, always turn OFF the machine main power
switch and unplug the power cord.
B064 Series/B140 Series
/B246 Series/D052 Series
CÓPIA NÃO CONTROLADA
B735I901.WMF
1-188
CÓPIA NÃO CONTROLADA
Rev. 09/2006
[B]
B735I903.WMF
SM