Seal Check And Removal - Ricoh M160 Service Manual

Data Overwrite Security Unit Type I
[System Settings] -> [Administrator Tools] -> [Administrator Authentication Management] ->
[Machine Management] -> [On]
If this setting is OFF, tell the customer this setting must be ON before you do the installation
procedure.
4. Make sure that "Administrator Tools" is enabled (selected).
[System Settings] -> [Administrator Tools] -> [Administrator Authentication Management] ->
[Machine Management] -> [On] -> [Select available settings]
If this setting is disabled (not selected), tell the customer this setting must be enabled
(selected) before you do the installation procedure.

Seal Check and Removal


You must check the box seals to make sure that they were not removed after the items
were sealed in the box at the factory before you do the installation.
1. Check the box seals [A] on each corner of the box.

Make sure that a tape is attached to each corner.

The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not install the
components in the box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the box.
3. You can see the "VOID" marks [B] when you remove each seal. In this condition, they cannot
be attached to the box again.
M160/M161 2-70 SM