Ricoh B064 SERIES Service Manual page 504

Hide thumbs Also See for B064 SERIES:

Table of Contents

B140/B246/D052 SERIES SERVICE MODE

Z-fold timing unit fold timing sensor adjustment error

The A/D (Digital/Analog) input

value did not change even after the

D/A (Digital/Analog) output value

Z-fold leading edge sensor adjustment error

The A/D input value did not change

even after the D/A output value

Z-fold EEPROM error

The write operation to the Z-folding

EEPROM failed after 2 attempts

Finisher staple trimming hopper full

The staple waste hopper is full of

cut staples.

B064 Series/B140 Series

/B246 Series/D052 Series

CÓPIA NÃO CONTROLADA

• Fold timing sensor connector loose,

• Fold timing sensor defective

• Fold timing sensor, mylar covered with

• Mylar disconnected.

• Leading edge sensor connector loose,

• Leading edge sensor defective

• Leading edge sensor, mylar covered with

• Mylar disconnected.

• EEPROM defective

• If the hopper is full, empty the hopper

• If the hopper is not full, the hopper full

CÓPIA NÃO CONTROLADA

broken, defective

broken, defective

sensor is disconnected, defective

Chapters

Table of Contents

B246 series B140 series D052 series