Before You Begin The Procedure; Seal Check And Removal - Ricoh MP C3004 Field Service Manual

2. Installation

Before You Begin the Procedure

1. Confirm that the Data Overwrite Security unit SD card is the correct type for the machine.
The correct type for this machine is "Type M19".
• If you install any version other than "Type M19" for this machine, you will have to replace the
NVRAM and do this installation procedure again.
2. Make sure that the following settings are not at their factory default values:
• Supervisor login password
• Administrator login name
• Administrator login password
If any of these settings is at a factory default value, tell the customer these settings must be changed
before you do the installation procedure.
3. Make sure that "Admin. Authentication" is ON.
User Tools > Machine Features > System Settings > Administrator Tools > Administrator
Authentication Management > Admin. Authentication
If this setting is OFF, tell the customer this setting must be ON before you do the installation
procedure.
4. Make sure that "Administrator Tools" is enabled (selected).
User Tools > Machine Features > System Settings > Administrator Tools >
Administrator Authentication Management> Available Settings
If this setting is disabled (not selected), tell the customer this setting must be enabled (selected)
before you do the installation procedure.
• See the Operating Instructions (Security Guide) for the factory default values.

Seal Check and Removal

Before opening the corrugated envelope, make sure that the seal has not been broken or peeled off. If
the seal has been broken or peeled off (even partially), this is considered an arrival defect. Note that
once the seal is peeled off, this will leave a mark on the bag.
448