Up Mode Settings For Wireless Lan - Ricoh B064 SERIES Service Manual

UP Mode Settings for Wireless LAN

Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 802.11. These settings take effect every time the machine is
powered on.
NOTE: The wireless LAN cannot be used if Ethernet is being used.
1. Press the User Tools/Counter key.
2. On the touch panel, press System Settings.
NOTE: The Network I/F (default: Ethernet) must be set for either Ethernet or
wireless LAN.
3. Select Interface Settings → Network (tab) → Network I/F Settting
4. Select either "Ethernet" or "IEEE 802.11b".
5. Press IEEE 802.11b. Only the wireless LAN options are displayed.
System Intialization Settings
Select the desired settings.
Network Parallel Interface
Transmission Speed
SSID Setting
Channel
WEP (Privacy) Setting
6. Transmission Mode. Select either "Ad Hoc Mode" or "Infrastructure Mode".
7. SSID Setting. Enter the SSID setting. (The setting is case sensitive.)
8. Channel. This setting is required when Ad Hoc Mode is selected.
Range: 1 ~ 14 (default: 11)
NOTE: The allowed range for the channel settings may vary for different
countries.
SM
CÓPIA NÃO CONTROLADA
IEEE 1394 IEEE 802.1b
802.11 Ad Hoc Mode
ASSID
11 Bandwidth Status
Disabled
1-149
CÓPIA NÃO CONTROLADA
MFP OPTIONS: B064 SERIES
End
1/2 Previous Next
B064I997.WMF
B064 Series/B140 Series
/B246 Series/D052 Series