Rev. 04/2008
⇒
1. Remove the shipping bracket [A] ( x
2).
2. Position the 2 mm spacer [B] and
secure the punch unit ( x 2).
3. Secure the punch unit at the front with
the shoulder screw [C] ( x 1).
4. Connect the harnesses [D] and clamp
them as shown.
NOTE: No special DIP switch settings
are required for this punch unit. The
punch unit sends an identification
signal to the machine, so it knows what
type of punch unit has been installed.
5. Slide the hopper [E] into the machine.
6. Fasten the two 1 mm spacers [F] to the
rear frame. These may be used during
future adjustments.
NOTE: The spacers are used to adjust
the horizontal positioning of the holes.
7. Reassemble the finisher and check the
punch operation.
SM
CÓPIA NÃO CONTROLADA
[C]
[E]
1-43
CÓPIA NÃO CONTROLADA
PUNCH UNIT (B377)
[A]
[B]
B377I203.WMF
[D]
B377I105.WMF
[F]
B377I106.WMF
B064 Series/B140 Series
/B246 Series/D052 Series