Ricoh B064 SERIES Service Manual page 208

MFP OPTIONS: B140/B246/D052 SERIES
40 to 60 mm
[B]
[A]
6. Remove the tape from the back of the Velcro patches [A]. Then, attach the
patches to the right rear corner of the main frame. Attach the antennas [B] to
the patches.
7. Put the connectors through the antenna cap [C].
8. Connect each antenna to a terminal [D] and attach the antenna cap.
NOTE: 1) You should attach the antennas as specified above for optimal
results. However if you place one or both antennas in a different
location, make sure that the antennas are separated by a minimum
of 40~60 mm (1.5~2.5").
2) Install the antennas in an area that is free of interference from
electrical equipment that causes a strong electromagnetic field.
3) Always remove the antennas from the corners of the machine and
disconnect them before you move the machine.
4) If reception is not good, move the machine and antennas nearer to
the access point.
9. Turn the machine on and print a configuration page to make sure that the
machine can see the installed IEEE 802.11b interface board:
User Tools> Printer Features> List Test Print> Configuration Page
B064 Series/B140 Series
/B246 Series/D052 Series
CÓPIA NÃO CONTROLADA
[C]
1-168
CÓPIA NÃO CONTROLADA
[D] B659I105.WMF
SM