Updating The Lcdc For The Operation Panel - Ricoh B064 SERIES Service Manual

Updating the LCDC for the Operation Panel

Use this procedure to update the LCDC (LCD Control Board).
1. Turn the copier main switch off.
2. Put the SD card into service slot C3.
3. Turn the copier main switch on.
4. Stop until the card utility screen is displayed.
5. After approximately 10 seconds, the initial screen opens in English.
6. Touch [Opepanel.DOM].
7. Touch [UpDate(#)] to start the update.
While the data downloads, the operation panel goes off.
The LED on the [Start] key flashes red at 1/2 second intervals for
approximately 6 minutes.
When the update is completed, the [Start] key starts to flash at 1-second
intervals.
8. Turn the copier main power switch off, remove the SD card, then turn the
copier on again.
Downloading Stamp Data
After you replace or format the HDD, download the stamp data from the controller
firmware to the hard disk.
1. Go into the SP mode.
2. Select SP5853 then press "Execute".
3. Obey the instructions on the screen to complete the procedure.
SD Card Boot (Forced Boot)
Use this procedure to boot up the machine if the boot area of the controller board
becomes corrupt In most cases, this procedure needs to be performed only once.
After that, the machine should be able to boot without the Boot SD Card If the
Machine still will not boot normally, even after performing this procedure,
investigate other potential failures (failed controller board, etc.).
1. Turn the main power off.
2. Insert the boot SD card into the C1 slot.
3. Set controller board DIP SW4 #5OFF, #6ON and #7 OFF.
4. Turn the main power ON
NOTE: After the machine boots up, it will install the firmware stored on the
boot SD Card.
5. Turn the main power OFF
SM
CÓPIA NÃO CONTROLADA
5-21
CÓPIA NÃO CONTROLADA
SOFTWARE UPDATE
B064 Series/B140 Series
/B246 Series/D052 Series