Ricoh B064 SERIES Service Manual page 141

4. Attach the sponge strip [A] that is supplied with the finisher.
5. Attach the guide plate (removed from the finisher) to the cover interposer.
• Attach the front end [B] of the plate ( x 1).
• Attach the rear end of the plate with the anti-static brush [C] ( x 1).
Important: Use the two small tapping screws that are supplied, not the
machine screws removed from the finisher guide plate.
6. Release the lock lever [D] ( x 1).
7. Attach the pad [E]. (This pad is provided with the finisher.)
8. Slowly push the finisher against the side of the machine until the brackets [F]
go into the slots.

WARNING!
Move the finisher carefully, or you will bend the
entrance guide plates.
9. Attach the lock lever [D] ( x 1).
10. Connect the connector [G] to the copier.
Important!
• Check the duct
• Make sure that the sponge does not prevent air
flow through this duct.
• Note: (B246/D054 Only) If the correct paper sizes
are not detected by the cover interposer after install,
manually put in the correct sizes via SP6107.
SM
CÓPIA NÃO CONTROLADA
[G]
[B]
[A]
on the left side of the machine.
1-101
CÓPIA NÃO CONTROLADA
COVER INTERPOSER TRAY (B704)
[C]
[E]
[D]
B704I106.WMF
B064 Series/B140 Series
/B246 Series/D052 Series
[F]
B132I734.WMF