Ricoh B064 SERIES Service Manual page 78

3000-SHEET FINISHERS (B468/B469/B674)
⇒
3. Remove the screw of the lock lever [A] and pull the lever out. Keep the screw.
4. Peel the cover tape from the sponge cushion [B], then install it in the upper slot.
NOTE: If you will also install the cover interposer tray, do not attach the
cushion here. Attach it to the cover interposer tray. The cover
interposer tray must be installed on the finisher before you attach the
finisher and tray to the main machine.
5. Align the brackets [C] with the slots in the finisher.
6. To avoid bending the entrance guide plates of the finisher, slowly push the
finisher against the side of the machine until the brackets enter the slots.
7. Fasten the lock lever [A] ( x 1) with the screw removed in Step 3. This locks
the finisher against the side of the mainframe.
8. Connect the plug [D] of the finisher power cord to the connector on the
machine.

CAUTION
Always move the finisher slowly to avoid bending the entrance guide
plates. Bent guide plates could interfere with paper transport from the
machine to the finisher.
B064 Series/B140 Series
/B246 Series/D052 Series
CÓPIA NÃO CONTROLADA
[B]
1-38
CÓPIA NÃO CONTROLADA
[D]
[A]
B468I004.WMF
Rev. 04/2008
[C]
SM