Using The Sp Mode - Ricoh B064 SERIES Service Manual

Using the SP Mode

SP command numbers can be entered directly (if you know the entire number) or
the command can be selected from the menus.
Direct Entry
SP5831 (Initial Setting Clear) is an executable SP that initializes the User Tools
settings, and can be executed immediately by entering the numbers.
1. Press .
2. Press "Enter ".
3. Press "Execute" on the touch panel.
If you know all seven digits of the SP code, enter the seven numbers and press
"Execute".
However, if you do not know all the numbers, enter only the first four numbers of
the seven-digit SP and press "Enter ". The display goes immediately to the first
SP of that group. Then you can use the buttons to browse to the desired selection.
Button Selection Entry
1. Refer to the SP Mode Tables at the end of this section to find the SP that you
want to adjust.
2. Press the Group number on the left side SP Mode window that contains the SP
that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the
SP number that you want to open, then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item
that you want to set, and press . The small entry box on the right is activated
and displays the default or the current setting below.
5. To enter a setting
• Press  to enter a minus sign. Then use the keypad to enter the appropriate
number. The number you enter will write over the previous setting.
• Press  to enter the setting. (If you enter a number that is out of range, the
key press is ignored.)
• When you are prompted to complete the selection, press Yes.
6. If you need to perform a test print, press "Copy Window" to open the copy
window and select the settings for the test print. Press "Start " twice, then
press "SP Mode" (highlighted) in the copy window to return to the SP mode
display.
7. When you are finished, press "Exit" twice to return to the copy window.
SM
CÓPIA NÃO CONTROLADA
5-3
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
B064 Series/B140 Series
/B246 Series/D052 Series