Ricoh B064 SERIES Service Manual page 578

SERVICE PROGRAM MODE TABLES
2940* Reface Mode
Controls if a blade bend prevention pattern is made when the ID sensor pattern is
made. This setting controls the pattern count. DFU
[0~100/1]
Increase the setting if the rotation of the drum is not smooth, that is, when drum
rotation is making noise.
2950 Vh Pattern Creation Setting (B140) DFU
001 Exposure Level
002 Offset Light Amount
2961 Developer Adjust Mode DFU
2962 Automatic Adjustment of Drum Conditions
Touch [Execute] to execute the process control cycle manually.
Note: This SP executes only if SP3901 is enabled.
2963 Installation Mode
Use the keyboard display to enter the lot number of the developer. (The lot number
is embossed on the top edge of the developer pack.)
Press "Execute" to initialize the developer and force toner supply to the toner
hopper at machine installation.
2964* Transfer Cleaning Blade Forming
001 Pattern Interval Setting
Selects the interval for application of a strip of toner across drum and transfer belt
to prevent the drum cleaning blade and belt cleaning blade from sticking and
bending against the drum or belt.
[0~200/1 copy] DFU
If set to zero, then no pattern is created.
002 Pattern Light Amount Setting
Adjusts the intensity of light that is used to create the blade protection pattern.
[0~4/1] DFU
003 Transfer Current On/Off Setting
Determines whether transfer current is switched on or off while the blade
protection pattern is created. DFU
Sets Off, toner is applied to the entire cleaning area and drum cleaning blade.
[0~1/1]
0: Off
1: On
B064 Series/B140 Series
/B246 Series/D052 Series
CÓPIA NÃO CONTROLADA
5-52
CÓPIA NÃO CONTROLADA
[0~15/1]
[-45 ~-100/1]
SM