Installation Procedure - Ricoh B064 SERIES Service Manual

1.15.2 INSTALLATION PROCEDURE

[C]
1. If the finisher is connected to the copier, disconnect the power connector [A]
and separate the finisher from the copier.
2. Remove the rear cover [B] ( x 2) and open the front door.
NOTE: At the base of the back cover, be sure to disconnect the tabs that
fasten the cover to the frame.
3. Remove the guide plate [C] ( x 2).
4. Slide the punch unit [D] along its rails into the finisher. Make sure that pin
engages correctly at the front and rear.
5. Connect and fasten the punch unit [E] ( x 2,  x 1).
NOTE: The connectors are coiled and tied above the PCB on the right.
SM
CÓPIA NÃO CONTROLADA
[B]
[A]
B702I102.WMF
Rear
1-87
CÓPIA NÃO CONTROLADA
PUNCH UNIT (B702)
[D]
Front
B702I103.WMF
B064 Series/B140 Series
/B246 Series/D052 Series
[E]
[F]