Z-Folding Unit (B660); Installation Procedure; Before You Begin - Ricoh B064 SERIES Service Manual

Rev. 04/2008

1.13.2 INSTALLATION PROCEDURE

Important!
⇒
• The Z-Folding Unit B660-17, -26, -27 can be installed and used only on the B674
Finisher (B140 series).
• The Z-Folding Unit B660-57, -66, -67 can be installed and used only on the B700
or B701 Finisher (B246 series).

Before You Begin

• Do the installation procedure for the finisher but do not dock it to the machine.
The Z-folding unit must be installed between the finisher and the main machine.
• Do the installation for the cover interposer tray (if necessary).
• If the finisher is already installed, disconnect the finisher from the main machine.
(If the cover interposer tray is installed on the finisher, it is not necessary to
remove the cover interposer tray.)
• Be cautious when installing the Z-Fold Unit B660. The unit may not be fully
stable until attached to the finisher. Be Careful not to tilt the Z-Fold Unit as you
perform the following procedures.
SM
CÓPIA NÃO CONTROLADA
1-67
CÓPIA NÃO CONTROLADA

Z-FOLDING UNIT (B660)

B064 Series/B140 Series
/B246 Series/D052 Series