Data Overwrite Security Unit Type C B735 - Ricoh B064 SERIES Service Manual

Rev. 09/2006
⇒

1.24.9 DATA OVERWRITE SECURITY UNIT TYPE C B735

Before You Begin The Procedure
1. Make sure that the following settings are not at their factory default values:
Supervisor login password
Administrator login name
Administrator login password
If any of these settings is at a factory default value, tell the customer these settings
must be changed before you do the installation procedure.

IMPORTANT NOTE
If the Customer forgets the Supervisor login password after changing it
from the default setting, a service call is required and the NVRAM must be
replaced to reset the Supervisor login and password.
2. Make sure that "Admin. Authentication" – "Machine Management" is ON.
[System Settings] – [Administrator Tools] – [Administrator Authentication
Management] - [Machine Management]
If this setting is OFF, tell the customer this setting must be ON before you do the
installation procedure.
3. Make sure that under Machine Management "Administrator Tools" is enabled
(selected).
[System Settings] – [Administrator Tools] – [Administrator Authentication
Management] – [Machine Management] - [Available Settings]
If this setting is disabled (not selected), tell the customer this setting must be
enabled (selected) before you do the installation procedure.
Accessory Check
The B246 series uses a Type C Data Overwrite Security Unit. Check the
accessories and their quantities against this list:
Description
1. SD Card ................................................................................ 1
SM
CÓPIA NÃO CONTROLADA
1-187
CÓPIA NÃO CONTROLADA
MFP OPTIONS: B246/D052 SERIES
Q'ty
B064 Series/B140 Series
/B246 Series/D052 Series