Usb Sp Settings - Ricoh B064 SERIES Service Manual

MFP OPTIONS: B064 SERIES

USB SP Settings

The following SP commands are available. However, only one setting may require
adjustment and this setting should be performed only if the customer is
experiencing USB data transmission errors.
NOTE: Do not change the settings marked "DFU". These settings are for design
and factory use only.
To enter the SP mode:
1. Press Clear Modes
2. On the operation panel keypad, press .
3. Hold down Clear/Stop  for more than 3 seconds.
4. Press "Copy SP" on the touch-panel to open the SP command selection
screen.
SP Mode (Service)
SP1XXX
SP2XXX
SP3XXX
SP4XXX
SP5XXX
SP6XXX
SP7XXX
SP8XXX
5. Enter .
SP No.
5844-001 Transfer Rate
5844-002 Vendor ID
5844-003 Product ID
5844-004 Dev. Release Num
B064 Series/B140 Series
/B246 Series/D052 Series
CÓPIA NÃO CONTROLADA

Open All Close All
Feed
Drum
Process
Scanner
Mode
Periphs
Data Log
Data Log2
Name
Adjusts the USB transfer rate. Do not change the setting
unless there is a data transfer error using the USB high
speed mode.
HS/FS:
FS:
Displays the vendor ID. DFU
Displays the product ID. DFU
Displays the development release version number. DFU
CÓPIA NÃO CONTROLADA
Copy Window SP Direct
COPY: SP1-001-001
Group
Page
Line
Line
Initial 0
Page
Group
Function
High speed/Full speed auto adjust
(480Mbps/12Mbps)
Full speed (12Mbps fixed)
1-142
14APR 2002 03:25
Exit
X-XXX-XXX
21
Prev Page Next Page
B064I999.WMF
SM