Up Mode Settings For Ieee 1394 - Ricoh B064 SERIES Service Manual

UP Mode Settings for IEEE 1394

Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 1394. These settings take effect every time the machine is
powered on.
1. Press User Tools/Counter.
2. On the touch panel, press System Settings.
3. Press Interface Settings.
System Intialization Settings
Select the desired settings.
Network Parallel Interface
IP Address
Subnet Mask
IP Over 1394
SCSI Print
4. Press the key and enter the following settings:
• IP Address
• Subnet Mask
• IP Over 1394. Enable or disable this setting as required. This setting enables
IP Over 1394 as the default setting for the printing method.
• SCSI Print. Enable or disable this setting as required. This setting enables
SCSI Print as the default setting for the printing method.
• SCSI Print Bi-directional. Switch bi-directional printing on or off for SCSI print.
SM
CÓPIA NÃO CONTROLADA
IEEE 1394 IEEE 802.1b
0000.0000.0000.0000 SCSI Print Bi-directional
0000.0000.0000.0000
Enabled
Enabled
1-145
CÓPIA NÃO CONTROLADA
MFP OPTIONS: B064 SERIES
End
On
B064I998.WMF
B064 Series/B140 Series
/B246 Series/D052 Series