Right Rear Corner Plate (B478/B706 Only); Attaching The Corner Plates For The B478/B706 - Ricoh B064 SERIES Service Manual

Hide thumbs Also See for B064 SERIES:

Table of Contents

COVER INTERPOSER TRAY (B470)

The corner plates are installed on the B478/B706 only. Attach the cover interposer

tray to the finisher before you attach the corner plates.

Right Rear Corner Plate (B478/B706 only)

1. Temporarily set the screws [A] (with approximately two turns) at the right end of

the finisher extension table [B] ( x 2, tapping M4 x 8)

NOTE: You cannot see the holes, because there is tape on them. Punch the

screws through the holes.

2. Align the notches [C] in the right rear corner plate [D] with the screws, and

attach the plate.

3. If there is a gap [E] between the plate and the tray extension attached to the

side of the finisher:

• Loosen the two screws below the table extension (not shown)

• Align the table extension with the corner of the finisher and the plate

• Tighten the tray extension screws.

4. With a long screw driver inserted through the notches in the right rear corner

plate [D], tighten the screws. This attaches the right rear corner plate to the

table extension [B].

B064 Series/B140 Series

/B246 Series/D052 Series

CÓPIA NÃO CONTROLADA

CÓPIA NÃO CONTROLADA

B470I009.WMF

Table of Contents

B246 series B140 series D052 series