Seal Check And Removal - Ricoh MT-C1 Service Manual

15 February 2006

Seal Check And Removal

[A]
!
CAUTION
Before you start the installation, you must check the box seals to make
sure that they were not removed after the items were sealed in the box at
the factory.
1. Check the box seals [A] on each corner of the box.
• Make sure that a tape is attached to each corner.
• The surfaces of the tapes should be blank.
Important: If you see "VOID" on the tapes, do not install the components in the
box. Stop the procedure and contact your Sales Division.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners
of the box.
3. After you remove each seal, the "VOID" marks [B] appear. This is normal.
MFP OPTIONS: B140/B246 SERIES
B692I901.WMF
1-171
[B]
B692I903.WMF