Data Overwrite Security Unit (B735); Before You Begin; Seal Check And Removal - Ricoh G147 Service Manual

1.8 DATA OVERWRITE SECURITY UNIT (B735)

1.8.1 BEFORE YOU BEGIN...

1. Confirm that the Data Overwrite Security unit SD card is the correct type for the
machine. The correct type for this machine is type "C".
If the NVRAM is replaced then the data overwrite security feature must be
replaced with the new data overwrite security option.
2. Make sure that the following settings are not at the factory default settings:
Supervisor login password
Administrator login name
Administrator login password
These settings must be set up by the customer before the Data Overwrite
Security unit can be installed. For details, contact the on-site system
administrator.

1.8.2 SEAL CHECK AND REMOVAL

Before you start the installation, check the box seals to make sure that they were
not removed after the items were sealed in the box at the factory.
1. Check the box seals [1] on each corner of the box.
Make sure that a tape is attached to each corner.
The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not
install the components in the box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of
the box.
If you see "VOID" on the tapes, do not install the components in the box. Stop
SM 1-21 G147