Displaying Commands And Command Syntax In Rom Monitor Mode (?, Help, -?) - Cisco 2800 Series Manual

How to Use the ROM Monitor—Typical Tasks
Examples
The following example shows how to set the configuration register to boot to ROM monitor mode:
Router>
Router> enable
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# config-register 0x0
Router(config)# exit
Router#
*Sep 23 16:01:24.351: %SYS-5-CONFIG_I: Configured from console by console
Router# write memory
Building configuration...
[OK]
Router# reload
Proceed with reload? [confirm]
*Sep 23 16:01:41.571: %SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload
command.
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
Initializing memory for ECC
.
Router platform with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Readonly ROMMON initialized
rommon 1 >
What to Do Next
Proceed to the
section on page

Displaying Commands and Command Syntax in ROM Monitor Mode (?, help, -?)

This section describes how to display ROM monitor commands and command syntax options.
SUMMARY STEPS
1.
2.
Using the ROM Monitor
8
"Displaying Commands and Command Syntax in ROM Monitor Mode (?, help, -?)"
8.
?
or
help
command -?
End with CNTL/Z.
OL-5997-02