Checking The Leds On Packet Processing Cards - Cisco ASR 5000 Installation Manual

Checking the LEDs on Packet Processing Cards

• PCMCIA device
• Nand Flash (used to store SMC firmware)
• Hard drive
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 7: SMC Busy LED States
Color
Green/
Blinking
Green
None
Checking the LEDs on Packet Processing Cards
Each packet processing card is equipped with status LEDs as shown in the following figure:
• Run/Fail
• Active
• Standby
• Status
• Service
ASR 5000 Installation Guide
12
Description Troubleshooting
Data is being read from No maintenance needed.
or written to one of the
memory devices. NOTE: If you are removing an SMC from the chassis, it is
recommended that you wait until this LED is off to ensure the
integrity of all data being transferred to or from the memory
device.
The memory devices are No maintenance needed.
not in use.
Applying Power and Verifying the Installation