Power Connection Compliance; Wiring The Dc-Input Power Source - Cisco ASR 901 10G Series Hardware Installation Manual

Mounting the Cisco ASR 901 10G Router
Figure 3-9
Step 6 Use a Phillips head screwdriver to attach the ground lug and wire assembly to the front of the router with
the two screws from the accessory kit.
Step 7 Connect the other end of the ground wire to a suitable grounding point at your site.

Power Connection Compliance

Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Use copper conductors only. Statement 1025
Warning
The installation must comply with the 2002 National Electric Code (NEC) and other applicable codes.
Note

Wiring the DC-Input Power Source

Before connecting the DC-input power source, you should install cable holders in front of the chassis.
Note
See
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than 10 A minimum, 60 VDC. Statement 1005
Complete the following steps to connect the DC power supply to the Cisco ASR 901 10G router:
Cisco ASR 901 10G Series Aggregation Services Router Hardware Installation Guide
3-12
Crimping a Ground Lug onto the Ground Wire
"Installing the DC Power Cord Retainer" section on page 13
Chapter 3 Installing the Cisco ASR 901 10G Router
on how to install cable holders.
OL-28105-02