Verifying Sdh Line And Section Parameters Configuration - Cisco ASR 900 Series Configuration Manual

Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
network-clock input-source 1 controller sdh 0/5/0
end

Verifying SDH Line and Section Parameters Configuration

Use show controllers command to verify SDH Line and Section Parameters Configuration:
#show controllers
sdh 0/3/0
SDH 0/3/0 is up.
Port configured rate: STM1
Applique type is Channelized SDH
Clock Source is Internal, AUG mapping is AU4.
Medium info:Type: SDH, Line Coding: NRZ,
Regenerator Section:LOS = 0 LOF = 0 BIP(B1) = 0SDH Section Tables
INTERVAL CV ES SES SEFS
04:19-04:19 0 0 0 0
Multiplex Section:AIS = 0 RDI = 0 REI = 0 BIP(B2) = 0
Active Defects: None
Detected Alarms: None
Asserted/Active Alarms: None
Alarm reporting enabled for: SLOS SLOF LAIS SF SD LRDI B1-TCA B2-TCA
BER thresholds: SF = 10e-5 SD = 10e-5TCA thresholds: B1 = 10e-6 B2 = 10e-5--More--*Apr 20
04:19:29.006 PDT: %CLEAR-5-COUNTERS: Clear counter on all interfaces Rx: S1S0 = 00K1 = 00,
K2 = 00J0 = 00RX S1 = 00Tx: S1S0 = 00K1 = 00, K2 = 00J0 = 00Tx J0 Length : 16Tx J0 Trace
:74 78 4D 65 73 73 61 67 65 20 20 20 20 20 20 00
txMessage .Expected J0 Length : 16Expected J0 Trace :72 78 4D 65 73 73 61 67 65 20 20 20
20 20 20 00
rxMessage .Rx J0 Length : 16Rx J0 Trace :CRC-7: 0xE7 ERROR01 01 01 01 01 01 01 01 01 01 01
01 01 01 01 00 ................SDH Line
Tables
INTERVAL CV ES SES UAS04:19-04:19 0 0 0 0
Configuring SDH Path Parameters
This section describes the configuration of SDH path parameters.
Path Overhead
C2 Flag
Sets the message length and the message text of the High Order Path Trace identifier (J1).
J1 Flag
Sets the C2 byte in the Path OverHead (POH) to indicate the contents of the payload inside the frame.
The path overheads, C2 flag and J1 flag can be configured for the following modes:
• AU-4 Mapping
• AU-3 Mapping
◦ Mode VC-4
◦ Mode VC-4 Nc
◦ Mode TUG-3
For more information, refer
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Verifying SDH Line and Section Parameters Configuration
Configuring Modes under AU-4 Mapping, on page 78.
ASR 900 Series)
93