Signals From Nc Channel - Siemens SINUMERIK 808D ADVANCED Parameter Manual

Detailed descriptions of interface signals
5.7 Channel-specific signals
corresponding to ...
Note for the reader
5.7.2

Signals from NC channel

DB3300
DBX0.3
Edge evaluation: No
Signal state 1
Note for the reader
DB3300
DBX0.4
Edge evaluation: No
Signal state 1
Note for the reader
DB3300
DBX0.5
Edge evaluation: No
Signal state 1
Signal state 0
392
IS "Active machine function 1 INC, ..."
for axis 1 in the Work (DB3300 DBX1001.0 ... .6)
for axis 2 in the Work (DB3300 DBX1005.0 ... .6)
for axis 3 in the Work (DB3300 DBX1009.0 ... .6)
IS "INC inputs active in the mode group area" (DB2600 DBX1.0)
Function Manual Basic Functions H1
Action block active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
Block search: Output of the collective auxiliary functions running.
Function Manual Basic Functions K1
Approach block active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
Block search with calculation / at contour: Approach block running
Function Manual Basic Functions K1
M0/M1 active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The part program block is executed, the auxiliary functions are output, and
● M0 is located in the work memory, or
● M1 is in the work memory and IS "Activate M01" is active
The program status changes to stopped.
● With IS "NC start"
● For a program abort as a result of a reset
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual