Siemens SINUMERIK 808D ADVANCED Parameter Manual page 490

SINAMICS V70 parameters
7.2 V70 parameters on BOP
Par. No. Name
r0069[0...6 Phase current actual value
]
Description: Displays the measured actual phase currents as peak value.
● [0] = Phase U
● [1] = Phase V
● [2] = Phase W
● [3] = Phase U offset
● [4] = Phase V offset
● [5] = Phase W offset
● [6] = Total U, V, W
In indices 3 ... 5, the offset currents of the 3 phases, which are added to correct the phase currents, are displayed.
The sum of the 3 corrected phase currents is displayed in index 6.
r0079[0...1 Torque setpoint total
]
Description: Displays the torque setpoint at the output of the speed controller (before clock cycle interpolation).
● [0]: Unsmoothed
● [1]: Smoothed
r0632 Motor temperature model, sta‐
tor winding temperature
Description: Displays the stator winding temperature of the motor temperature model.
p0918 Drive Bus address
Description: Displays or sets the Drive Bus address for Drive Bus interface on the servo drive.
The address can be set as follows:
Using p0918
● Only if the address 00 hex, 7F hex, 80 hex, or FF hex has been set using the address switch.
● The address is saved in a non-volatile fashion using the function "copy from RAM to ROM".
● A change only becomes effective after a POWER ON.
p1058 Jog 1 speed setpoints
Description: Sets the speed/velocity for jog 1. Jogging is level-triggered and allows the motor to be incrementally
moved.
p1082 Maximum speed
Description: Sets the highest possible speed.
Dependency: p0322
p1083 Speed limit in positive direction
of rotation
Description: Sets the maximum speed for the positive direction.
p1086 Speed limit in negative direction
of rotation
Description: Sets the speed limit for the negative direction.
490
Min Max Factory
setting
- - -
- - -
- - -
10 15 10
0 210000.0 100
00
0.000 210000.0 1500.00
00 0
0.000 210000.0 210000.
00 000
-210000. 0.000 -210000
000 .000
Unit Data type Effective
A Float -
Nm Float -
°C Float -
- U16 RE
rpm Float IM
rpm Float IM
rpm Float IM
rpm Float IM
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Can be
changed
-
-
-
T
T
T
T, U
T, U
Parameter Manual