Siemens SINUMERIK 808D ADVANCED Parameter Manual page 403

DB3300
DBX4006.0
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB3300
DBX4006.0
Edge evaluation: No
Signal state 1
Signal state 0
Corresponding to ...
Note for the reader
DB3500
DBB0 - 63
Edge evaluation: No
Signal status > 1
Signal state 0
Special cases, er‐
rors, ...
Note for the reader
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
ASUB active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
One ASUB is active.
No ASUB is active.
Function Manual Basic Functions K1
ASUB active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
An ASUB with suppressed display update is active (refer to MD20191).
No ASUB with suppressed display update is active.
MD20191 IGN_PROG_STATE_ASUP
(do not display execution of the interrupt program on the OPI)
Function Manual Basic Functions K1
Active G function of groups 1 to 64
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Event-controlled
A G function of the G group is active.
The active G group is saved in the dual format in the byte involved, e.g. G90:
0 1 0 1 1 0 1 0
No G function of the G group is active.
In contrast to auxiliary functions, G functions are not output to the PLC subject
to acknowledgement, i.e. processing of the part program is continued imme‐
diately after the G function output.
Programming Manual, Fundamentals
Detailed descriptions of interface signals
5.7 Channel-specific signals
403