Siemens SINUMERIK 808D ADVANCED Parameter Manual page 393

Application
Corresponding
to ...
Note for the
reader
DB3300
DBX0.6
Edge evaluation: No
Signal state 1
Note for the reader
DB3300
DBX1.0
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
Corresponding to ...
Note for the reader
DB3300
DBX1.2
Edge evaluation: No
Signal state 1
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
IS "Activate M01"
IS "M01 selected"
Function Manual Basic Functions K1
Last action block active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
Block search: Last block of the output with collected auxiliary functions.
Function Manual Basic Functions K1
Referencing active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The channel-specific referencing was started using the IS: "Activate refer‐
encing" and the successful start was acknowledged using IS "Referencing
active". The channel-specific referencing is running.
● Channel-specific referencing has been completed
● Axis-specific referencing is running
● No referencing active
Spindles
IS "Activate referencing" (DB3200 DBX1.0)
Function Manual Basic Functions R1
Revolutional feedrate active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
When programming of G95 (revolutional feedrate) in the JOG or automatic
mode.
Detailed descriptions of interface signals
5.7 Channel-specific signals
393