Siemens SINUMERIK 808D ADVANCED Parameter Manual page 15

Designator
UNSIGNED DWORD
DOUBLE
FLOAT DWORD
UBYTE
LONG
System
Specifies the control system for which the data with the entered values applies.
By default, the entered values apply for both the SINUMERIK 808D ADVANCED T (Turning)
and the SINUEMRIK 808D ADVANCED M (Milling).
If no "default" entry exists, the data only applies for the control variants specified:
808d-te62
808d-me62
Default values
Specifies a default value fort he machine data. If the default values for the channels are
different, they are separated with a comma ",".
Range of values (minimum/maximum value)
Specifies the limits for the entered values. If no range of value is specified, the data type
determines the input limits, and the field is marked with a dash "-".
Protection
The control system provides a concept of access levels for enabling data areas. The access
levels correspond with protection levels 0 to 7 (0: the highest level; 7: the lowest level). You
can view such information from the table shown as below:
Protection level
0
1
2
3
4
5
6
7
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Meaning
I32-bit value
● As an INTEGER value: 0 to 4,294,967,295
● As a hexadecimal value: 0000 0000 to FFFF FFFF
64-bit value
● Floating point value: ±4.19 x 10
Real value: ±7.43 x 10
Integer value: 0 to 255
Integer value: 4,294,967,296 to 4,294,967,295
SINUMERIK 808D ADVANCED T (Turning)
SINUMERIK 808D ADVANCED M (Milling)
Access level
Siemens -
Manufacturer SUNRISE
Reserved
Customer CUSTOMER
- Key-operated switch setting 3
- Key-operated switch setting 2
- Key-operated switch setting 1
No password -
Explanation of machine data and setting data
to ±1.57 x 10
-307
to 3.37 x 10
-37 38
Default password
2.1 Data in the list
308
Target group
Reserved for Siemens
Machine manufacturers
End users
End users
End users
End users
-
15