Siemens SINUMERIK 808D ADVANCED Parameter Manual page 113

20090 SPIND_DEF_MASTER_SPIND
- Initial setting of master spindle in channel
-
- -
Description:
Definition of the default setting for the master spindle (in the channel).
The number of the spindle is entered.
A number of functions are linked to the master spindle, which are not possible with
any other spindle.
Note:
The language command SETMS(n) can declare the spindle number as the master spindle.
The spindle defined in this MD is declared once again as the master spindle with SETMS.
The spindle defined in this MD is also declared as the master spindle at program end
and program cancelation.
20094 SPIND_RIGID_TAPPING_M_NR
- M function for switching into controlled axis mode
-
- -
Description:
This machine data defines the M auxiliary function number with which the spindle is
switched into axis mode.
The M number defined in the machine data replaces M70 in Siemens language mode.
Note:
On the VDI interface, M70 is always output with the corresponding address extension to
indicate the switch to axis mode.
Restrictions: Refer to machine data MD10715 $MN_M_NO_FCT_CYCLE
Related to:
MD10714 $MN_M_NO_FCT_EOP,
MD10715 $MN_M_NO_FCT_CYCLE,
MD20094 $MC_SPIND_RIGID_TAPPING_M_NR,
MD22254 $MC_AUXFU_ASSOC_M0_VALUE
MD10814 $MN_EXTERN_M_NO_MAC_CYCLE,
MD20095 $MC_EXTERN_RIGID_TAPPING_M_NR
20095 EXTERN_RIGID_TAPPING_M_NR
- M function for switching to controlled axis mode(external mode)
-
- -
Description:
This machine data defines the M function number with which the switchover to
controlled spindle/axis mode is to be carried out.
The M number defined in the machine data replaces M29 in external language mode.
Pre-defined M numbers, such as M00,M1,M2,M3, etc., are not allowed as M numbers.
Restrictions: See machine data MD10715 $MN_M_NO_FCT_CYCLE
Related to:
MD10714 $MN_M_NO_FCT_EOP,
MD10715 $MN_M_NO_FCT_CYCLE,
MD20094 $MC_SPIND_RIGID_TAPPING_M_NR,
MD22254 $MC_AUXFU_ASSOC_M0_VALUE
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
- 1
70, 70, 70, 70, 70, 70, -
70, 70...
29, 29, 29, 29, 29, 29, -
29, 29...
3.3 Channel-specific machine data
C01, C03 H2, K1, K2, P3 pl, P3 sl, S1, W1
BYTE PowerOn
1 1/1
C01, C03, C10 H2, K1, S1
DWORD PowerOn
- 2/2
C01, C11, C03, H2, K1
C10
DWORD PowerOn
- 2/2
Machine data
M
M
M
113