Siemens SINUMERIK 808D ADVANCED Parameter Manual page 271

MD is Corresponds with:
MD20850 $MC_SPOS_TO_VDI
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET
MD35020 $MA_SPIND_DEFAULT_MODE
SD43200 $SA_SPIND_S
35040 SPIND_ACTIVE_AFTER_RESET
- Own spindle RESET
CTEQ
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET defines the response of the spindle after channel
reset NC/PLC interface signal DB3000 DBX0.7 (Reset) and program end (M2, M30).
This MD is only active in the spindle mode open-loop control mode. In positioning mode
or oscillation mode, the spindle is always stopped.
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET = 0:
●
Spindle stops (with M2/M30 and channel and mode group reset).
●
Program is canceled.
●
For spindle mode, the programmed ACC and VELOLIM are reset to 100% if MD22400
$MC_S_VALUES_ACTIVE_AFTER_RESET and the axis-specific MD32320
$MA_DYN_LIMIT_RESET_MASK do not specify anything else.
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET= 1:
●
Spindle does not stop.
●
Program is canceled.
●
For spindle mode, the programmed ACC and VELOLIM are retained.
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET= 2:
●
Spindle does not stop at the M function configured via MD10714 $MN_M_NO_FCT_EOP
(e.g. M32).
●
However, the spindle stops at channel or mode group reset.
●
For spindle mode, the programmed ACC and VELOLIM are retained.
The NC/PLC interface signal DB380x DBX2.2 (Delete distance-to-go/Spindle reset) is
always effective, independent of MD35040 $MA_SPIND_ACTIVE_AFTER_RESET.
Not relevant to:
●
Spindle modes other than open-loop control mode.
Related to:
NC/PLC interface signal DB3000 DBX0.7 (Reset)
NC/PLC interface signal DB380x DBX2.2 (Delete distance-to-go/Spindle reset)
35090 NUM_GEAR_STEPS
- Number of gear stages
-
- -
Description:
Number of set gear stages.
The first gear stage is always available.
Corresponding MDs:
MD35010 $MA_GEAR_STEP_CHANGE_ENABLE (gear stages available/functions)
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
2 0
2 0
2 0
2 0
0 0
0 0
5 1
3.4 Axis-specific machine data
A06, A10 S1, Z1, 2.7
BYTE PowerOn
2 1/1
2 1/1
2 1/1
2 1/1
2 1/1
2 1/1
A06, A10 S1
DWORD Reset
5 1/1
Machine data
271