Siemens SINUMERIK 808D ADVANCED Parameter Manual page 345

4:
5:
43300 ASSIGN_FEED_PER_REV_SOURCE
- Revolutional feedrate for positioning axes/spindles
CTEQ
- -
Description:
0=
>0=
feedrate is derived.
-1=
which the axis/spindle is active
-3=
which the axis/spindle is active. No revolutional feedrate is active if the master
spindle is at a standstill.
Related to ....
which a frame with rotation acts in JOG mode.)
43320 JOG_POSITION
mm, degrees JOG position
-
- -
Description:
Position to be approached in JOG. Depending on MD10735 $MN_JOG_MODE_MASK bit 4 axial
frames and, with an axis configured as geometry axis, the tool length offset are
considered.
43340 EXTERN_REF_POSITION_G30_1
- Reference point position for G30.1
-
- -
Description:
Reference point position for G30.1.
This setting data will be evaluated in CYCLE328.
43400 WORKAREA_PLUS_ENABLE
- Working area limitation active in positive direction
CTEQ
- -
Description:
1: The working area limitation of the axis concerned is active in the positive
direction.
0: The working area limitation of the axis concerned is switched off in the positive
direction.
The setting data is parameterized via the operator panel in the operating area
"Parameters" by activating/deactivating the working area limitation.
SD irrelevant for ......
G code: WALIMOF
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
ACP approach position from the positive direction.
ACN approach position from the negative direction.
0
No revolutional feedrate is active.
Machine axis index of the rotary axis/spindle, from which the revolutional
The revolutional feedrate is derived from the master spindle of the channel in
The revolutional feedrate is derived from the master spindle of the channel in
SD42600 $SC_JOG_FEED_PER_REV_SOURCE (revolutional feedrate for geometry axes on
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
0.0
0.0
FALSE
-
DWORD
-3 31
-
DOUBLE
- -
, A12
DOUBLE
- -
-
BOOLEAN
0 -
NC setting data
V1, P2, S1
Immediately
1/1 M
-
Immediately
7/7 U
FBFA
Immediately
7/7 U
A3
Immediately
7/7 U
345