Siemens SINUMERIK 808D ADVANCED Parameter Manual page 181

24050 FRAME_SAA_MODE
- Saving and activating of data management frames
-
- -
Description:
Bit mask for saving and activating data management frames.
The following applies:
Bit 0:
Data management frames are only activated by programming the bit masks $P_CHBFRMASK,
$P_NCBFRMASK and $P_CHSFRMASK. G500..G599 only activate the relevant settable frame,
GFRAME0..GFRAME100 only activate the corresponding grinding frame. The reset behavior
is independent of this.
Bit 1:
Data handling frames are not written implicitly by system functions such as TOROT,
PAROT, ext. work offset, transformations.
24080 USER_FRAME_POWERON_MASK
- Parameterize properties for settable frame
-
- -
Description:
Setting the following bits activates certain properties of the settable frame:
Bit 0 = 0: default behavior.
Bit 0 = 1: if MD20152 $MC_GCODE_RESET_MODE[7] = 1, the last active settable frame is
selected again according to G code group 8 after power up of the control.
24100 TRAFO_TYPE_1
- Definition of transformation 1 in channel
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This MD specifies the first available transformation in each channel.
The 4 low-value bits identify the specific transformation of a specific transformation
group. The transformation group is identified by a number starting with the 5th bit.
Meaning:
0
ab 16
5-axis transformation with turnable tool
ab 32
5-axis transformation with turnable workpiece
ab 48
5-axis transformation with turnable tool and turnable workpiece
72
Generic 5-axis transformation. Type and kinematic data are determined by an
associated, orientable toolholder.
see:
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
No transformation
3.3 Channel-specific machine data
C03
DWORD
0 0x0000003
N01
DWORD
0 0x1
C07
DWORD
- -
- -
- -
- -
- -
- -
Machine data
-
PowerOn
1/1 M
-
PowerOn
7/2 M
F2, TE4, M1, K1, W1
NEW CONF
1/1 M
1/1 M
1/1 M
1/1 M
7/7 U
7/7 U
181