Siemens SINUMERIK 808D ADVANCED Parameter Manual page 35

10136 DISPLAY_MODE_POSITION
- Display mode for actual position in the work
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Defines how the position and the distance to go are displayed in the Work.
0:
1:
programmed end point, irrespective of where the machine actually is (e.g. as a result
of the tool radius compensation). The distance to go is the same as the actual distance
to be traversed. This means that the displayed actual postion has to be the same as
the displayed end position minus the distance to go, irrespective of the actual
machine position. If the block end points are changed by chamfers, radii, contour
definitions, splines or SAR in comparison to the NC programm, then these changes are
reflected in the display as if thay had been programmed. This does not apply to changes
resulting from tool radius compensation or smoothing.
10160 PREP_COM_TASK_CYCLE_RATIO
- Factor for communication with HMI
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This machine data specifies the division ratio used for activating the communication
task in the non-cyclic time level. This allows the time share of preparation in the
non-cyclic time level to be increased, which reduces block cycle times. External
communication (file transfer) is slowed down in particular during program execution
(block reload).
10175 PLC_TASK_RUNTIME_WARNING
s Prewarning limit for computation time exceeded SW-PLC2xx
-
- -
Description:
The machine data defines the duration for the prewarning of the computation time
exceeded for SW-PLC2xx in seconds. After this time has expired, SW-PLC2xx generates
display alarm 400026 "PLC cycle time has exceeded the alarm threshold".
10192 GEAR_CHANGE_WAIT_TIME
s Gear stage change waiting time
-
- -
Description:
External events which trigger reorganization, wait for the end of a gear stage change.
GEAR_CHANGE_WAIT_TIME now determines the waiting time for the gear stage change. Time
unit in seconds.
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
1
1
1
1
0
0
Display as in software version 5 and earlier
At end of block, the actual value display is in principle the same as the
3
3
3
3
3
3
0.000393
10.0
N01
DWORD
0 1
0 1
0 1
0 1
0 1
0 1
EXP, N01
DWORD
1 50
1 50
1 50
1 50
1 50
1 50
EXP, N01
DOUBLE
0.0 0.000436
N01
DOUBLE
0.0 1.0e5
Machine data
3.2 General machine data
-
Reset
1/1
1/1
1/1
1/1
1/1
1/1
ECO
PowerOn
0/0
0/0
0/0
0/0
7/1
7/1
ECO
PowerOn
1/1
S1
PowerOn
1/1
35