Siemens SINUMERIK 808D ADVANCED Parameter Manual page 55

Only active for the ISO mode turning: The tool number and offset number are programmed
in the T word. $MN_DIGITS_TOOLNO defines the number of leading digits, which form the
tool number.
Example:
$MN_DIGITS_TOOLNO = 2
T=1234
Bit0=1:
Only active in the ISO mode turning: Only the tool number is programmed in the T word.
Offset number == tool number. $MN_DIGITS_TOOLNO is irrelevant.
Example:
T=12
Bit1=0:
Only active in the ISO mode turning:
If the number of digits programmed in the T word is the same as the number defined in
MD10888 $MN_EXTERN_DIGITS_TOOL_NO, then leading 0s are added
Bit1=1:
Is only active for the ISO mode turning:
If the number of digits programmed in the T word is the same as the number of digits
specified in MD10888 $MN_EXTERN_DIGITS_TOOL_NO, the programmed number is the offset
number and tool number
Bit2=0:
Is only active for the ISO mode turning: ISO T offset selection only with D (Siemens
cutting edge number)
Bit2=1:
Is only active for the ISO mode turning: ISO T offset selection only with H
($TC_DPH[t,d])
Bit6=0:
that tool length and tool radius are always selected when either H or D is programmed.
Bit6=1:
so that the number of the tool length value is selected when H is programmed, and the
number of the tool radius value is selected when D is programmed.
Bit7=0:
Is only active for the ISO mode turning. If T substitution ( MD10717
$MN_T_NO_FCT_CYCLE_NAME ) is active, the H number programmed in the T word is
transferred to the cycle in the variable $C_D.
Bit7=1:
Is only active in the ISO mode turning. If T substitution ( MD10717
$MN_T_NO_FCT_CYCLE_NAME ) is active, the Siemens cutting edge number D corresponding
to the H number programmed in the T word is transferred to the cycle in the variable
$C_D.
10900 INDEX_AX_LENGTH_POS_TAB_1
- Number of positions for indexing axis table 1
-
- -
Description:
The indexing position table is used to assign the axis positions in the valid unit of
measurement (mm, inches or degrees) to the indexing positions [n] on the indexing
axis. The number of indexing positions used in table 1 is defined by MD10900
$MN_INDEX_AX_LENGTH_POS_TAB_1.
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
; tool number 12,
; offset number 34
; tool number 12
; offset number 12
The offset memories for the tool length and tool radius are linked so
The offset memories for the tool length and tool radius are not linked,
0
N09
DWORD
0 60
Machine data
3.2 General machine data
T1
Reset
2/2
55