Siemens SINUMERIK 808D ADVANCED Parameter Manual page 70

Machine data
3.2 General machine data
the handwheels connected to
a hardware module:
0
1..6
11353 HANDWHEEL_LOGIC_ADDRESS
- Logical handwheel slot addresses
-
808d-me42 6
808d-me62 6
808d-te42 6
808d-te62 6
808d-mte40 6
808d-mte60 6
Description:
For PROFIBUS/PROFINET only:
Logical start address of the hand wheel slots if handwheels are connected by PROFIBUS/
PROFINET (MD11340 $MN_HANDWHEEL_SEGMENT = 5)
11354 HANDWHEEL_FILTER_TIME
s Filter time for handwheel pulses
-
808d-me42 6
808d-me62 6
808d-te42 6
808d-te62 6
808d-mte40 6
808d-mte60 6
Description:
The filter time indicates the time during which the pulses from the handwheel are
output to the interpolator. The values are incremented internally in interpolation
cycles.
In the case of a filter time setting = 0.0, the pulses from the handwheel are output
to the interpolator within a single interpolation cycle. This can cause the controlled
axis to exhibit jerk during traversing.
Machine data is valid for the following types of handwheel (see 11350
$MN_HANDWHEEL_SEGMENT):
SEGMENT_ETHERNET:
●
Recommended filter time:
11450 SEARCH_RUN_MODE
- Parameterization for search run
-
- -
Description:
The behavior during the action blocks after block search can be affected by the
following bits:
Bit 0 = 0:
70
= No handwheel configured
= Handwheel connection to HW module/Ethernet interface
0, 0, 0, 0, 0, 0
0, 0, 0, 0, 0, 0
0, 0, 0, 0, 0, 0
0, 0, 0, 0, 0, 0
0, 0, 0, 0, 0, 0
0, 0, 0, 0, 0, 0
0.0, 0.0, 0.0, 0.0, 0.0,
0.0
0.0, 0.0, 0.0, 0.0, 0.0,
0.0
0.0, 0.0, 0.0, 0.0, 0.0,
0.0
0.0, 0.0, 0.0, 0.0, 0.0,
0.0
0.0, 0.0, 0.0, 0.0, 0.0,
0.0
0.0, 0.0, 0.0, 0.0, 0.0,
0.0
0.2 - 0.5 s
0x40
N04, N10
DWORD
0 16383
0 16383
0 16383
0 16383
0 16383
0 16383
N09
DOUBLE
0.0 2.0
0.0 2.0
0.0 2.0
0.0 2.0
0.0 2.0
0.0 2.0
EXP, N01
DWORD
0 0xFF
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
H1
PowerOn
ReadOnly
ReadOnly
ReadOnly
ReadOnly
7/2
7/2
-
PowerOn
ReadOnly
ReadOnly
ReadOnly
ReadOnly
7/2
7/2
K1, TE3, N4, H2, Z1
PowerOn
1/1
Parameter Manual