Siemens SINUMERIK 808D ADVANCED Parameter Manual page 309

As configuration 0, except for thread cutting (G33, G34, G35) and tapping (G331, G332,
G63). These functions are executed as programmed.
11:
As configuration 1, except for thread cutting (G33, G34, G35) and tapping (G331, G332,
G63). These functions are executed as programmed.
12:
As configuration 2, except for thread cutting (G33, G34, G35) and tapping (G331, G332,
G63). These functions are executed as programmed.
42110 DEFAULT_FEED
mm/min Path feed default value
-
- -
Description:
Default value for path feedrate, This setting data is evaluated when the part program
starts taking into account the feedrate type active at this time (see MD20150
$MC_GCODE_RESET_VALUES and MD20154 $MC_EXTERN_GCODE_RESET_VALUES).
42120 APPROACH_FEED
mm/min Path feedrate in approach blocks
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Default value for path feedrate in approach blocks (after repos., block search,
SERUPRO etc).
The contents of this settting data are only used when it is non-zero.
It is evaluated like an F word programmed for G94.
42121 AX_ADJUST_FEED
mm/min Path feed in adjustment movements
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
- V1, FBFA
DOUBLE Immediately
- 7/7
- -
DOUBLE Immediately
- 2/2
- 2/2
- 2/2
- 2/2
- 7/7
- 7/7
- -
DOUBLE Immediately
- 2/2
- 2/2
- 2/2
- 2/2
- 7/7
- 7/7
NC setting data
U
M
M
M
M
U
U
M
M
M
M
U
U
309