Siemens SINUMERIK 808D ADVANCED Parameter Manual page 67

Immediate travel in the opposite direction if the handwheel is turned at least the
stated number of pulses in the opposite direction.
Whether this machine data is also active for handwheel travel with DRF depends on bit10
of MD20624 $MC_HANDWH_CHAN_STOP_COND.
11320 HANDWH_IMP_PER_LATCH
- Handwheel pulses per detent position
-
- 6
Description:
The connected handwheels are adapted to the control in MD11320
$MN_HANDWH_IMP_PER_LATCH.
The number of pulses generated by the handwheel for each handwheel detent position has
to be entered. The handwheel pulse weighting must be defined separately for each
connected handwheel (1 to 3). With this adaptation, each handwheel detent position has
the same effect as one press of the traversing key in incremental traversal.
Entering a negative value reverses the direction of rotation of the handwheel.
Related to:
11322 CONTOURHANDWH_IMP_PER_LATCH
- Contour handwheel pulses per detent position
-
- 6
Description:
Adaptation factor to the hardware of the contour handwheel:
Enter the number of pulses issued per detent position by the contour
handwheel.
Because of this normalization, a detent position of the contour handwheel
corresponds to one press of a key with incremental jog processes.
Sign reversal reverses the direction of evaluation.
11330 JOG_INCR_SIZE_TAB
- Increment size for INC/handwheel
-
- 5
Description:
In incremental traversal or handwheel travel, the number of increments to be traversed
by the axis can be defined by the user, e.g. via the machine control panel.
In addition to the variable increment size (INCvar), 5 fixed increment sizes (INC...)
can also be set.
The increment size for each of these 5 fixed increments is defined collectively for
all axes by entering values in JOG_INCR_SIZE_TAB [n]. The default setting is INC1,
INC10, INC100, INC1000 and INC10000.
The entered increment sizes are also active for DRF.
The size of the variable increment is defined in SD41010 $SN_JOG_VAR_INCR_SIZE.
Related to:
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
1., 1., 1., 1., 1., 1. -
MD31090 $MA_JOG_INCR_WEIGHT
(weighting of an increment of a machine axis for
INC/manual).
1., 1., 1., 1., 1., 1. -
1., 10., 100., 1000., 0.0
10000.
MD31090 $MA_JOG_INCR_WEIGHT (weighting of an increment for INC/manual)
NC/PLC interface signal DB3300 DBX1001.0-4,1005.0-4,1009.0-4
(Geometry axis 1-3 active machine function: INC1; ...; INC10000)
NC/PLC interface signal DB390x DBX5.0 - .5
3.2 General machine data
N09 H1
DOUBLE PowerOn
- 2/2
N09 H1
DOUBLE PowerOn
- 2/2
EXP, N09 H1
DOUBLE PowerOn
- 1/1
Machine data
67