Siemens SINUMERIK 808D ADVANCED Parameter Manual page 43

10707 PROG_TEST_MASK
- Program test mode
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Bit-coded mask for program test
Bit 0 == 1
Bit 1 == 1
Bit 2 == 1
processing. If the bit is set, the program test is active in all channels with
accelerated feed via the VDI signal in the first channel. The VDI signal has no effect
in all other channels as long as the bit is set. The value in $MC_SERUPRO_SPEED_FACTOR
of the first channel is used as the feed. Only released for test purposes.
Bit 3 == 1
Bit 4 == 1
channel mode.
Bit 5..31
Program test with normal processing is always activated via the VDI interface.
Program test in simulation is always activated via the NCKMode PI.
Program test block search is always activated via the Find-Pi.
10709 PROG_SD_POWERON_INIT_TAB
- Setting data to be initialized
-
- 30
Description:
Setting data to be initialized:
The values of the programmable SD indicated in this MD are set to their initial values
on control power up.
Only the setting data listed in the table below, however, can be initialized. If
invalid setting data numbers are configured, then the alarm 4009 is output at the next
run-up of the control. The alarm shows the index used for configuring the invalid
setting data. The alarm can only be eliminated by changing the invalid setting data,
i.e. by entering either a valid number or zero!
SD42000 $SC_THREAD_START_ANGLE
SD42010 $SC_THREAD_RAMP_DISP
SD42125 $SC_SERUPRO_SYNC_MASK
SD42400 $SC_PUNCH_DWELLTIME
SD42402 $SC_NIBPUNCH_PRE_START_TIME
SD42404 $SC_MINTIME_BETWEEN_STROKES
SD42800 $SC_SPIND_ASSIGN_TAB
SD43200 $SA_SPIND_S
SD43202 $SA_SPIND_CONSTCUT_S
SD43210 $SA_SPIND_MIN_VELO_G25
SD43220 $SA_SPIND_MAX_VELO_G26
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
0x1 0
0x1 0
0x1 0
0x1 0
0x11 0
0x11 0
Program test cannot be deselected in 'Stopped' program status.
Enable to activate the program test using the PI command _N_NCKMOD
Activation of program test with accelerated feed in normal program
Activation of program test with accelerated feed in the simulation.
Activation of accelerated program test takes place in synchronized multi-
As yet unused.
43200, 43202, 0, 0, 0, -
0, 0, 0...
3.2 General machine data
N01 K1
DWORD PowerOn
0x1B 1/1
0x1B 1/1
0x1B 1/1
0x1B 1/1
0x1F 1/1
0x1F 1/1
EXP, N01 K1
DWORD PowerOn
- 2/2
(GCODE)
SF
DITS/DITE
PDELAYON
SETMS
S wih G94,G95,G97,G971,G972
S with G96,G961,G962
G25 S
G26 S
Machine data
43