Siemens SINUMERIK 808D ADVANCED Parameter Manual page 303

41110 JOG_SET_VELO
mm/min Axis velocity in JOG
-
- -
Description:
Value not equal to 0:
The velocity value entered applies to linear axes traversed in JOG mode if linear
feedrate (G94) is active for the relevant axis (SD41100 $SN_JOG_REV_IS_ACTIVE = 0).
The axis velocity is active for
●
continuous jogging
●
incremental jogging (INC1, ... INCvar)
●
handwheel traversing.
The value entered is valid for all linear axes and must not exceed the maximum
permissible axis velocity (MD32000 $MA_MAX_AX_VELO).
In the case of DRF, the velocity defined by SD41110 $SN_JOG_SET_VELO is reduced by
MD32090 $MA_HANDWH_VELO_OVERLAY_FACTOR.
Value = 0:
If 0 has been entered in the setting data, the active linear feedrate in JOG mode is
MD32020 $MA_JOG_VELO "Jog axis velocity". Each axis can be given its own JOG velocity
with this MD (axial MD).
SD irrelevant for ......
●
Linear axes if SD41100 $SN_JOG_REV_IS_ACTIVE = 1
●
Rotary axes (SD41130 $SN_JOG_ROT_AX_SET_VELO is active here)
Application example(s)
The operator can thus define a JOG velocity for a specific application.
Related to ....
SD41100 $SN_JOG_REV_IS_ACTIVE (revolutional feedrate with JOG active)
Axial MD32020 $MA_JOG_VELO (JOG axis velocity)
Axial MD32000 $MA_MAX_AX_VELO (maximum axis velocity)
Axial MD32090 $MA_HANDWH_VELO_OVERLAY_FACTOR (ratio of JOG velocity to handwheel
velocity (DRF))
SD41130 $SN_JOG_ROT_AX_SET_VELO (JOG speed with rotary axes)
41120 JOG_REV_SET_VELO
mm/rev Revolutional feedrate of axes in JOG mode
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Value not equal to 0:
The velocity value entered applies to axes traversed in JOG mode if revolutional
feedrate (G95) is active for the relevant axis (SD41100 $SN_JOG_REV_IS_ACTIVE = 1).
The axis velocity is active for
●
continuous jogging
●
incremental jogging (INC1, ... INCvar)
●
handwheel traversing. The value entered is valid for all axes and must not exceed
the maximum permissible axis velocity (MD32000 $MA_MAX_AX_VELO).
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
- H1
DOUBLE Immediately
- 7/7
- H1
DOUBLE Immediately
- 1/1
- 1/1
- 1/1
- 1/1
- 7/7
- 7/7
NC setting data
U
M
M
M
M
U
U
303