Siemens SINUMERIK 808D ADVANCED Parameter Manual page 436

Detailed descriptions of interface signals
5.8 Axis / spindle-specific signals
Edge change 0 → 1 or 1
→ 0
Application
corresponding to ...
Note for the reader
DB390x
DBX1002.4
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB390x
DBX1002.5
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB390x
DBX1002.6
Edge evaluation: No
Signal state 1
436
As soon as the axis / spindle has traveled through the distance set in
MD33050, the "lubrication pulse" interface signal is inverted and lubrication
is started.
The position measurement is restarted after each Power On.
The lubrication pump for the axis / spindle can be activated with IS "Lubrica‐
tion pulse". Machine bed lubrication therefore depends on the distance trav‐
eled.
MD33050 LUBRICATION_DIST (lubrication pulse distance)
Function Manual Basic Functions A2
Path axis
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
The axis is involved in the path (path axis).
The axis is not involved in the path.
Function Manuals
Positioning axis
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
The NCK handles the axis as positioning axis. This means that it has:
● its own axis interpolator (linear interpolator)
● its own feedrate (F value)
● its own feedrate override
● exact stop (G09) at the progr. end position
The axis is not a positioning axis.
Function Manual, Expansion Functions P2
Indexing axis in position
Signal(s) from axis / spindle (NCK → PLC)
Signal(s) updated: Cyclic
The signal is dependent on "Exact stop fine":
The signal is set if "Exact stop fine" is reached. The signal is reset when
exiting "Exact stop fine".
● The indexing axis is located on an indexing position.
● The indexing axis has been positioned with instructions for "Coded
Position".
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual