Siemens SINUMERIK 808D ADVANCED Parameter Manual page 158

Machine data
3.3 Channel-specific machine data
Bit 15 = 0:
If an axis with active diameter programming is traversed in the channel, only half the
distance of the specified increment is traveled during handwheel travel (MD11346
$MN_HANDWH_TRUE_DISTANCE = 1 or 3
Bit 15 = 1:
If an axis with active diameter programming is traversed in the channel, the specified
increment is fully traveled during handwheel travel (MD11346 $MN_HANDWH_TRUE_DISTANCE
= 1 or 3).
Bit 16 = 0:
Return traveling is possible to the start of the block.
Bit 16 = 1:
Return traveling is not possible (response as at start of block, i.e. pulses are
ignored).
20700 REFP_NC_START_LOCK
- NC start disable without reference point
-
- -
Description:
0:
or part program blocks (MDI and overstore) is active even if one or all axes of the
channel have not yet been referenced.
To ensure that the axes nevertheless reach the correct position after NC startup, the
work (workpiece coordinate system = work) must be set to the correct value by means of
other methods (scratch method, automatic work offset determination etc.).
1:
point is mandatory (value > -1), must be referenced for NC startup to be enabled.
2:
of "referenced") is sufficient for NC startup in MDI or overstore.
20730 G0_LINEAR_MODE
- G0 interpolation mode
-
- -
Description:
This machine data defines the interpolation behavior of G0:
0:
axis (positioning axis), independently of the other axes, at the rapid traverse
velocity of the axis (MD32000 $MA_MAX_AX_VELO).
1:
20734 EXTERN_FUNCTION_MASK
- Function mask for external language
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This machine data is used to influence functions in ISO mode.
Bit0: 0:
158
1, 1, 1, 1, 1, 1, 1, 1...
The NC/PLC interface signal DB3200 DBX7.1 (NC start) for starting part programs
Axes for which the axial MD34110 $MA_REFP_CYCLE_NR specifies that a reference
Advanced form of setting 1 in that the axis state "Position restored" (instead
TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
Non-linear interpolation (RTLIOF): Each path axis interpolates as an individual
Linear interpolation (RTLION): The path axes are interpolated jointly.
0x4800
0x4800
0x4800
0x4800
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
C01, C03
BYTE
0 2
C09
BOOLEAN
0 -
N12
DWORD
0 0xFFFF
0 0xFFFF
0 0xFFFF
0 0xFFFF
0 0xFFFF
0 0xFFFF
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
D1, R1, Z1
Reset
2/2 M
P2
PowerOn
2/2 M
-
Reset
1/1 M
1/1 M
1/1 M
1/1 M
1/1 M
1/1 M
Parameter Manual