Signals From / To Hmi - Siemens SINUMERIK 808D ADVANCED Parameter Manual

Signal state 0
corresponding to ...
Note for the reader
5.3

Signals from / to HMI

5.3.1 Program control signals from HMI
DB1700
DBX0.3
Edge evaluation: No
Signal state 1
Signal state 0
corresponding to ...
Note for the reader
DB1700
DBX0.5
Edge evaluation: No
Signal state 1
Signal state 0
corresponding to ...
Note for the reader
DB1700
DBX0.6
Edge evaluation: No
Signal state 1
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
The main run reads in preprocessed part program blocks.
IS "Program status running"
DRF selected
Signal(s) from HMI → PLC
Signal(s) updated: Cyclic
The operator has selected DRF on the operator panel front. The PLC pro‐
gram (basic PLC program or user program) transfers this HMI interface signal
to the interface signal corresponding to the logic operation:
Activate DRF.
As soon as DRF is active, the DRF offset can be changed in the AUTOMATIC
or MDI mode using the handwheel assigned to the axis.
The operator has not selected DRF on the operator panel front.
JOG mode
Activate DRF
M01 selected
Signal(s) from HMI → PLC
Signal(s) updated: Cyclic
Activate program control M1 has been selected from the operator interface.
This does not activate the function.
Activate program control M1 has not been selected from the operator inter‐
face.
IS "Activate M01"
IS "M0/1 active"
Function Manual Basic Functions K1
Dry run feedrate selected
Signal(s) to channel (HMI → PLC)
Signal(s) updated: Cyclic
Dry run feedrate is selected.
Instead of the programmed feedrate, the dry run feedrate entered in SD
42100: DRY_RUN_FEED is active.
When activated from the operator panel, the dry run feedrate signal is auto‐
matically entered in the PLC interface and transferred by the PLC basic pro‐
gram to the PLC interface signal "Activate dry run feedrate".
Detailed descriptions of interface signals
5.3 Signals from / to HMI
357