Siemens SINUMERIK 808D ADVANCED Parameter Manual page 149

20482 COMPRESSOR_MODE
- Mode of compressor
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This MD is used to set the compressor operating mode.
The units digits, the tens digits and the hundreds digits have different meanings.
The following options are available:
Units digits:
0:
are met for all axes (geometry and orientation axes).
1:
$SC_COMPRESS_CONTUR_TOL are active for the geometry axes.
For the orientation axes, the axis-specific tolerances MD33100 $MA_COMPRESS_POS_TOL
are active.
2:
become active for the geometry axes. The orientation movement is compressed in
compliance with the maximum angular deviations specified with SD42476
$SC_COMPRESS_ORI_TOL or SD42477 $SC_COMPRESS_ORI_ROT_TOL.
3:
becomes active for the geometry axes and the maximum angular deviation SD42476
$SC_COMPRESS_ORI_TOL or SD42477 $SC_COMPRESS_ORI_ROT_TOL becomes active for the
orientation axes.
Tens digits:
The tens digits of this MD can be used to set a compressor response that is compatible
with previous software releases (< SW 6.3).
0x:
This is the default setting.
Notice: This response is incompatible with previous software releases!
1x:
2x:
(e.g. A3= B3= C3=).
3x:
compressed. With this setting, the response is fully compatible with previous software
releases (< 6.3).
Hundreds digits:
The hundreds digit can be used to set which blocks in addition to G01 blocks are to be
compressed or not:
0xx: Circular blocks and G00 blocks are not compressed. Is compatible with previous
releases.
1xx: Circular blocks are linearized and compressed by COMPCAD.
2xx: G00 blocks are compressed; a different tolerance may be applied here (see MD 20560
$MC_G0_TOLERANCE_FACTOR).
3xx: Combination of the two previous options: Both circular blocks and G00 blocks are
compressed.
The thousands digits optimize the compressor for different machine types:
0xxx: Optimization for a good surface quality in tool and mold building.
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
0, 0, 0, 0, 0, 0, 0, 0...
300
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
With the compressor, the tolerances specified with MD33100 $MA_COMPRESS_POS_TOL
With the compressor, the contour tolerances specified with SD42475
With the compressor, the axis-specific tolerances MD33100 $MA_COMPRESS_POS_TOL
With the compressor, the contour tolerance SD42475 $SC_COMPRESS_CONTUR_TOL
All blocks with orientations and value assignments are compressed.
Blocks with value assignments are not compressed (e.g. X=100 ..., etc.)
Blocks with a programmed tool orientation are not compressed.
All blocks with value assignments and/or programmed tool orientation are not
3.3 Channel-specific machine data
EXP
DWORD
0 1333
0 1333
0 1333
0 1333
0 1333
0 1333
Machine data
F2
NEW CONF
1/1 M
1/1 M
0/0 S
0/0 S
7/7 U
7/7 U
149