Siemens SINUMERIK 808D ADVANCED Parameter Manual page 224

Machine data
3.4 Axis-specific machine data
31060 DRIVE_AX_RATIO_NUMERA
- Numerator load gearbox
-
- 6
Description:
The load gearbox numerator is entered in this MD.
The index [n] of the machine data has the following coding:
[control parameter set no.]: 0-5
31070 DRIVE_ENC_RATIO_DENOM
- Denominator measuring gearbox
-
- 1
Description:
The measuring gearbox denominator is entered in this MD.
The index [n] of the machine data has the following coding:
[encoder no.]: 0 or 1
31080 DRIVE_ENC_RATIO_NUMERA
- Numerator measuring gearbox
-
- 1
Description:
The measuring gearbox numerator is entered in this MD.
The index [n] of the machine data has the following coding:
[encoder no.]: 0 or 1
31090 JOG_INCR_WEIGHT
mm, degrees Evaluation of an increment with INC/handwheel
CTEQ
- 2
Description:
The value entered in this MD defines the path of an increment which applies when an
axis is traversed with the JOG keys in incremental mode or with the handwheel.
The path traveled by the axis on each increment each time the traversing key is pressed
or for each handwheel detent position is defined by the following parameters:
●
MD31090 $MA_JOG_INCR_WEIGHT
(Weighting of an increment of a machine axis for INC/handwheel)
●
Selected increment size (INC1, ..., INCvar)
The possible increment stages are defined globally for all axes in MD11330
$MN_JOG_INCR_SIZE_TAB [n] and in SD41010 $SN_JOG_VAR_INCR_SIZE.
Entering a negative value reverses the direction of evaluation of the traverse keys
and the handwheel rotation.
Related to:
MD11330 $MN_JOG_INCR_SIZE_TAB
SD41010 $SN_JOG_VAR_INCR_SIZE
31092 JOG_INCR_WEIGHT_TRAFO
mm, degrees Evaluation of an increment for INC/handwheel for active
transformation
CTEQ
- 2
224
1, 1, 1, 1, 1, 1 -2147000000
1, 1 1
1, 1 1
0.001, 0.00254 -
0.0, 0.0 -
A02, A11 A2, A3, G2, S1, V1
DWORD PowerOn
2147000000 2/2
A02, A11 A3, G2, S1
DWORD PowerOn
2147000000 2/2
A02, A11 A3, G2, S1
DWORD PowerOn
2147000000 2/2
A01, A12 H1, G2
DOUBLE Reset
- 2/2
A01, A12 H1, G2
DOUBLE Reset
- 2/2
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
Parameter Manual