Siemens SINUMERIK 808D ADVANCED Parameter Manual page 135

20173 SURF_VELO_TOL
mm/min Maximum permitted deviation of the path feed on compression
with COMPSURF
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
The value specifies the maximum permitted deviation for compression for the path feed.
The larger the value, the more short blocks can be compressed into one long block.
20191 IGN_PROG_STATE_ASUP
- Do not display interrupt program execution on OPI
-
- -
Description:
If the ASUB is started, OPI variables
progStatus and chanStatus do not change, i.e. the HMI does not see this normally short
program execution.
Bit 0 is assigned to interrupt channel 1.
Bit 1 is assigned to interrupt channel 2, etc.
Korrespondiert mit:
MD11602 $MN_ASUP_START_MASK
MD20115 $MC_IGNORE_REFP_LOCK_ASUP
MD20116 $MC_IGNORE_INHIBIT_ASUP
MD20117 $MC_IGNORE_SINGLEBLOCK_ASUP
MD20194 $MC_IGNORE_NONCSTART_ASUP
20192 PROG_EVENT_IGN_PROG_STATE
- Do not display the Prog-Event on OPI
-
- -
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
1000.0, 1000.0, 0.0
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
1000.0, 1000.0, 0.0
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
1000.0, 1000.0, 0.0
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
1000.0, 1000.0, 0.0
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
1000.0, 1000.0, 0.0
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
1000.0, 1000.0, 0.0
1000.0, 1000.0,
1000.0, 1000.0,
1000.0, 1000.0...
0, 0, 0, 0, 0, 0, 0, 0... 0
0x0, 0x0, 0x0, 0x0, 0
0x0, 0x0, 0x0, 0x0...
3.3 Channel-specific machine data
C09 -
DOUBLE PowerOn
- 1/1
- 1/1
- 0/0
- 0/0
- 7/2
- 7/2
EXP K1
DWORD NEW CONF
0x7FFFFFFF 2/2
EXP -
DWORD NEW CONF
0x3F 2/2
Machine data
M
M
S
S
M
M
M
M
135